NSVS1100 Mar-04 JRC SAW FILTER UNDER NSVS1100 DEVELOPMENT Application 243.95MHz PHS 1st IF Electrical Specification: (Table 1) The device characteristics are measured in the circuit shown in Fig.1. Table 1. Electrical Specifications Item Nominal Center Frequency (f0) 3dB Band Width Insertion Loss at f0 Ripple f0100kHz Group Delay Time Ripple f0100kHz Attenuation f0600kHz f010.7MHz f021.4MHz - Spec. 243.95MHz 130kHz 4.0dB 1.0dB 1.0us 25dB 40dB 60dB - Typ. 3.0dB 0.40dB 0.40us 30dB 60dB 65dB - Maximum Rating: (Table 2) Table 2. Maximum Ratings Item Maximum Input Power Operating Temperature Range Storage Temperature Rating +5dBm -10~+60C -40~+85C Mechanical Specifications: (Fig.2) Package is designed as small as 3.0x3.0x1.15[mm3] for SMD (Surface Mount Device) type. Notice: This part is electrostatic discharge sensitive and may be damaged by improper handling. Communications Equipment Division Communications Equipment Marketing Department 10-1, Nishi-Shinjuku 6-chome, Shinjuku-ku, Tokyo, 160-8328 Japan Tel. +81 3-3348-3845 Fax. +81 3-3348-3935 http://www.jrc.co.jp/jp/product/device/saw/index.html (Japanese) http://www.jrc.co.jp/eng/product/comm/device/saw/saw_top_e.html (English) NSVS1100 Mar-04 1 OUT 50 8 7 2 SAW 6 3 4 5 UNDER DEVELOPMENT IN 50 Fig.1 Measuring circuit (b ) (a ) 3. 00 .15 (c) 3.00. 15 430 S3 (1 ) 4 (0 .5 5) 1 .150 .1 5 ( 2) 3 2 (1 .2) 6 (0 .6) [4 x] 5 1 8 (0 .7 5) [6x] (0 .53) [4x] 7 Fig.2 Package dimensions (in mm) 3.8 0.6 1.15 3.8 0.6 0.93 1.15 0.93 Via-Hole( 0.3) Fig.3 Desirable land area (in mm) Marking (1) Lot Number (a) Year (b) Month Oct. --Nov. --Dec. --(c) Date 0- 9 10 - 19 20 - 31 (2) Part number Mark Pin no. 1 2 3 4 5 6 7 8 X Y Z 0 1 2 Connection GND GND IN/OUT GND OUT/IN GND OUT/IN GND NSVS1100 Mar-04 Notice 1. Use this component within operating temperature range. It might not be satisfied with electrical specification without operating temperature range. When it is used less than -10C or more than +60C, it might be a cause of degradation or destruction of the component. Even if it endures during a short time, it causes degradation of qualification. 2. When soldering iron is used, solder with the temperature at the tip of soldering iron: 350C max., the time of soldering: 10 seconds max., the power of soldering iron: 30W max.. 3. Notice that the allowed time of soldering with soldering iron is accumulated time, when soldering is repeated. 4. As rapid temperature change for cleaning after reflow soldering might be a cause of destruction clean this component after confirming that temperature of this component goes down to room temperature. 5. Confirm that there are not any influence for qualification to this component in mounting on PCB when this component is cleaned. 6. As it might be a cause of degradation of destruction to apply static electricity to this component, do not apply static electricity or excessive voltage while assembling and measuring. And do not transport this component with bare hand. Note 1. This specification specifies the quality of this component as a single unit. Make sure that this component is evaluated and confirmed against this specification when it is mounted to your products. 2. The information contained herein may be changed without prior notice. It is therefore advisable to contact Japan Radio Company before proceeding with the design of equipment incorporating this product. NSVS1100 Mar-04 UNDER DEVELOPMENT LQW18ANR11G00 (Murata) 110nH OUT LQW18ANR11G00 (Murata) 110nH 1 8 7 2 SAW 6 3 4 5 IN GRM1554C1H2R0Z01 (Murata) 2pF 50 GRM1554C1H2R0Z01 (Murata) 2pF 50 Fig.4 NSVS1100 Smith Chart Insertion Loss 0 S11 2 4 6 8 [dB] 10 243.45 243.95 Frequency[MHz] 244.45 S22 Return Loss [5dB/div] Center Freq. 243.95 [MHz] Freq.Span 0 [MHz] Japan Radio Co.,Ltd NSVS1100 0 Smith Chart Insertion Loss S11 20 40 60 80 [dB] 100 242.45 243.95 Frequency[MHz] 245.45 S22 Return Loss [5dB/div] Center Freq. 243.95 [MHz] Freq.Span 2 [MHz] Japan Radio Co.,Ltd NSVS1100 0 Smith Chart Insertion Loss S11 20 40 60 80 [dB] 100 238.95 243.95 Frequency[MHz] 248.95 S22 Return Loss [5dB/div] Center Freq. 243.95 [MHz] Freq.Span 9 [MHz] Japan Radio Co.,Ltd NSVS1100 0 Smith Chart Insertion Loss S11 20 40 60 80 [dB] 100 218.95 243.95 Frequency[MHz] 268.95 S22 Return Loss [5dB/div] Center Freq. 243.950008 [MHz] Freq.Span 50 [MHz] Japan Radio Co.,Ltd NSVS1100 Group Delay 5000 4000 3000 2000 1000 [ns] 0 243.45 243.95 244.45 Frequency[MHz] Japan Radio Co.,Ltd