2000 MODULAR CONSOLE- SERIES ASSEMBLY INSTRUCTIONS FOR BASE UNIT TO PEDESTAL BUL10077 REV. A PAGE 1 OF 1 PRE - ASSEMBLY INSTRUCTIONS: Gasket Surface Caution: Check gasket on top of pedestal unit and base unit for damage before assembly. If cut or torn, contact Hammond Manufacturing for immediate replacement. Note: When assembling total modular system build from the floor up for assembly ease. Plinth > Pedestal > Base Unit > Base Cover 1 3 x4 4 x4 See STEP E for instructions Gasket Surface 5 x4 2 ASSEMBLY INSTRUCTIONS: A) Open or remove doors on base unit for ease of assembly. This will allow for visual alignment of mating parts. B) Remove .5 dia knockouts in bottom of base unit before assembly. C) Align base unit (item 1) over top opening in pedestal (item 2). Side edges of base unit and pedestal are to be flush. PARTS LIST ITEM No. DESCRIPTION BASE UNIT 1 PEDESTAL 2 3/8-16 X 3/4 HEX CAP SCREW 3 3/8 SEALING WASHER 4 3/8 HEX NUT 5 TOOL BOX 9/16 Socket Wrench 9/16 Open Wrench #2 Phillips Screw Driver QTY 1 1 4 4 4 D) Front and rear holes in base unit bottom are to be aligned with mounting holes on pedestal top. E) Once the base unit is seated properly on pedestal assemble using 3/8-16 x .75 hex head bolts and 3/8 nuts and sealing washers (item 3, 4 & 5). Torque bolts and nuts to 180 in/lbs. Hammer HAMMOND MANUFACTURING TM ELECTRONICS GROUP visit our website @ www.hammondmfg.com